• Reclaim used water for use in waterjet cutting
• Reclaim up to 99% of your water
• Reuse of water makes it green and saves you money
• Crystal clear water at the lowest cost
• Designed specifically for waterjet cutting

• Don’t throw money down the drain
• Affordable and easy water recycling solution
• No expensive deionization supplies
• Easy upkeep
• Made in the USA

What is the WRS-3000?

WARDJet’s approach to water recycling is a 3-phase process. The WRS-3000 is phase 2 in that process, designed specifically to remove suspended solids in the water. A chiller is included for both the cooling and cutting water. If you are currently using tap water to cool your pump, the chiller can eliminate this water requirement.

Why do I need a WRS-3000?

With rising water costs and increased regulations regarding water quality that can be sent to drain, a solution is needed to allow for proper disposal or better yet, reuse, of water to avoid extra costs. WARDJet developed the WRS-3000 as an alternative to expensive and time intensive methods of Water Recycling.

How much of a difference will the WRS-3000 make?

With the proper configuration, you should expect to reclaim up to 95% of your used water. If cutting with water only, you can expect to reclaim up to 99%.

Is there much maintenance cost and upkeep involved in the WRS-3000?

No. Simple guages and lights alert you when there is a need to change filters. These filters are easily available and extremely affordable to replace, especially compared to expensive de-ionization methods.

How is the WRS-3000 different from other recycling solutions?

The WRS-3000 focuses on filtering spent cutting water of materials that specifically would harm intensifier pumps used in waterjet cutting. The filtered water leaving the WRS-3000 has a quality better than most tap water, thus increasing pump seal life and the life of your high pressure components.

WRS-3000 vs. Traditional Filtration

Click to enlarge (PDF)

Video

High Quality